Return to previous page
Following are pictures of the newest Shoptask Quadralift as of July 2000.
These pictures are of and were taken by Art Rosenfelder of Colorado
Following is the text Art posted to the Shoptask Users forum (the non-company forum) on Delphi.
Jerry and all,
I will try to give the info you need. The four plates are (starting at bottom) 3/4" thick,1/4",3/8" and 1/4" thick on top. The entire length of the four posts are the same smoothness but I'm not sure if the spacers (steel bushings) are machined, reamed or are just a slip fit. I would have to take the lift apart to be able to tell. There does not seem to be any play in the affair even while taking a cut of 30 thou or so in aluminum. There is no way to adjust for perpindicular except for shimming but I dont see that as being much of a problem. Once you shimmed the entire unit for plumb, you could also shim under the millhead casting and the second plate if needed. The Quadralift seems very sturdy and I can see it would be much more stable than the original swivel mount.
Arthur Rosenfelder
Rosenfelder Optics
RoseOptics@aol.com
Return to previous page
